Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

KMT STELLRAM - каталог решений для высокопроизводительного фрезерования - 2014 год EN

                                  для размещения заказа - kennametal@kennametal.su          5230VS Series
                                                                                        Technical Information

5230VS09 and VS12 Fitting Instructions for Shell Mill Cutters

NOTE: All Shell Mill 5230VS09 and VS12 Chevron Porcupine Cutters are supplied
assembled with mounting bolt, nord lock washer and steel coolant plug.

Please follow the instructions below to disassemble the cutter, attach the cutter to a
shell mill adapter and reassemble coolant plug. It is very important to use the proper
torque when reassembling the cutter with the mounting bolt, nord lock washer and
coolant plug.

Example of cutter: 5230VS12-A063Z4R94 assembly

COOLANT PLUG                      NORD LOCK WASHER                                      CUTTER BODY
SB-3230                           NLW-.375                                              5230VS12-A063Z4R94

                                  MOUNTING SCREW
                                  M12-1.75 ISO 30MM SHCS

Close                 Open
Serrations            Serrations

REFIT COOLANT
PLUG ENSURING
NORD LOCK WASHER
IS PRESENT AND
ASSEMBLE AS THIS
PICTURE WITH GREASE.

1.	Remove coolant plug. (Note: Ensure the nord lock washer is retained to the bottom of the coolant plug.)

2.	Fit the cutter body to the shell mill adapter and secure using the mounting bolt supplied with the cutter.
	 Note: The mounting bolt must be properly torqued to the specified torque setting shown in the above chart in (page 62) Detail 1.

3. Refit coolant plug ensuring nord lock washer is present and in the proper location on the bottom of the coolant plug.
	 A small amount of grease can be used to hold the nord lock washer in place.

4. Tighten coolant plug with specified torque setting shown in the above chart in (page 62) Detail 2.

5. Note: If axial depth of cut (ap) is less then maximum ap of the cutter, then F3006T coolant control screws supplied
	 separately can be used to block coolant holes forcing more coolant to the front of the cutter. If these screws are used,
	 please secure with loctite or similar product.

www.kennametal.su                                                                                                                   61

                                  для заказа - kennametal@kennametal.su
Заявка