KMT STELLRAM - каталог решений для высокопроизводительного фрезерования - 2014 год EN

5702VZD & 5720VZ       для размещения заказа - kennametal@kennametal.su
Technical Information

5720 Case History

                       Material: Aluminium 2024
                       Cutter: 5720VZ (32mm Cutter)
                       Component: Seat Support
                       Industry Segment: Aerospace
                       Insert Grade: GH1
                       Spindle Speed: 17,491 RPM
                       Cutting Speed Vc: 1758 m/min
                       Feed per Tooth fz: 0,25mm
                       Feed rate: 8745 mm/min
                       Depth of Cut: 2,5mm

                       Result: 400% Increase in Productivity

5720 High Speed Geometry

                -721 N

                                 This extreme high positive geometry is highly suitable for machining Aluminium Alloys,
                                 Copper and Brass. This geometry is periphery ground with a pressed, polished top rake face
                                 reducing built up edge. Especially qualified when machining thin-walled components.

High Speed Grade

                 GH1 N

                                  Uncoated, Micrograin

                                  This micrograin grade is designed for use on Aluminium Alloys, Copper, Brass and Kevlar
                                  etc. The grade GH1 works well with or without coolant with low cutting pressure at high
                                  speeds due to sharp cutting edge.

                          Material Guide – Key to Recommended Inserts

                                                             Material Designation

   P Unalloyed Steels P Alloyed Steels M Stainless Steels M PHStainless K Cast Irons N Aluminum & Alloys S High Temp. Alloys H Hard Materials

84 www.kennametal.su

                                                               для заказа - kennametal@kennametal.su