KMT STELLRAM - каталог решений для высокопроизводительного фрезерования - 2014 год EN

5702VZD14                             для размещения заказа - kennametal@kennametal.su
Profiling / Pocketing Milling Cutter

               d1                     Product                          Dimensions (mm)                                                     Spares

L                               EDP Item Description D L/H l1                        d1   ap   No. of  Insert radius  EDP                  EDP                  Screw
       I1                                                                                 max  Teeth      range                                               Tightening
               D
                                      5702VZD14 Cylindrical Shank                                                                                                Nm*
Cylindrical Shank
                                028998 5702VZD14CA020R58-2  20 108 58                20 12     2 < 2,00 015060 F2505T 018488                        T7           0,80
                                028999 5702VZD14CA020R58-4  20 108 58                20 12     2 2,50 to 4,00 015060 F2505T 018488                  T7           0,80

                                * It is important to change the screw each time the insert is changed to ensure the highest security.
                                A dynamometric key and the right torque value are important. See above for the correct torque information.

                                5702VZD Technical Information (mm)

                                      Product                                        Dimensions

                                EDP   Item Description      Facing Ramping                   Helical Hole  ap max       Max
                                                            Pitch Angle °                    min. - max.   Helical /    RPM
                                                                                                            Linear
                                028998 5702VZD14CA020R58-2  20 11.0*                      26,8 38,0                     43000              Ramping         Helical
                                028999 5702VZD14CA020R58-4  20 11.0*                      26,8 38,0          3,00       43000                           Interpolation
                                                                                                             3,00

                                * Max. ramping angle for insert is calculated with facet                                                            Flat

                                Find the different ramping angles for all available insert radii on technical information page 90.

                                Radial depth of cut 0,20mm up to full cutter diameter.                                                          Facing Pitch

                                These tools have been designed, manufactured and tested in accordance with
                                EN ISO standard 15641:2001.

                                These tools are stocked without an electronic chip.

                                Note: If using a insert with radius, then the facing pitch for the 5702VZD cutter is equal to the cutting
                                diameter (D) minus 2 x chosen radius.	

                                Cylindrical Shanks or Special HSK Integral Shanks are designed and balanced to G6.3 at
                                30,000 RPM for diameters 50mm and below. Diameters larger then 50mm are balanced to

                                G6.3 at 24,000 rpm.

                            ap  Cylindrical Shank tools mounted in a shrink fit holder or any other mill chuck holder + inserts + screws
Depth of Cut (ap)               must be re-inspected for balance as an assembly by the end user when at or exceeding 8,000 rpm. End
88
                                user must balance the assembly to a G6.3 value minimum.

                                Additional Balancing and Torque values can be found in the technical section pages 91.

                                                                                                                               www.kennametal.su

                                               для заказа - kennametal@kennametal.su