KMT STELLRAM - полный каталог инструмента

                       для размещения заказа - kennametal@kennametal.su                             7745VSE
                                                                                         Technical Information

775VSE Technical Information                                                                                          End Mills & Face Mills

Feed rate compensation: For 45° cutting, divide the hm value by the
sine of the approach angle (the sine of 45° = 0,707)

i.e.: hm   or 0,08mm

0,707                  0,707	 = 0,11mm programmed feed rate

Calculation of the average chip thickness in relation with the ae (Radial Engagement) if ae is less than 50% of Dia.

Formula: Programme Feed Rate (fz)  hm	 =	Average chip thickness      Formula: Average Chip Thickness (hm)
                                   ae	 =	Radial engagement
fz = hm x          d               fz	 =	Feed per tooth                   hm = fz x  ae
                   ae              d	 = 	Cutter diameter                             d

www.kennametal.su                                                                        A105

                                   для заказа - kennametal@kennametal.su

KMT STELLRAM - полный каталог инструмента - 2014 год EN