KMT STELLRAM - полный каталог инструмента - 2014 год EN
для размещения заказа - kennametal@kennametal.su
8000V-8010V Face Milling Cutters
Applications
Cartridge Face Mills 8000V CUTTERS WITH UNEQUALPITCH
The cutters in the 8000V series ( 100 – 400mm) with interchangeable
8000V Cutter cartridges have a medium pitch and an unequal division of teeth. This
8010V Cutter design has been developed through extensive studies of their vibration
phenomena. They are especially recommended for surfacing cast
structures and all other parts with drilled holes or thin walled sections,
as well as for square shoulder face milling. For a given table feed, the
medium pitch allows a lower feed rate per tooth which avoids the risks of
damage to sides or recesses of the machined parts.
These are quick-change cartridges thanks to a heel which comes up
against a setting track. The runout achieved is in the order of 0,05mm.
If a greater degree of precision is required, they can easily be adjusted
individually with a runout of 2-5 µm. In case of accidental shocks, the
heel disengages automatically from the track and the tool body remains
intact.
8010V CUTTERS WITH EQUALPITCH
For machining High Temperature Alloys, we have modified our milling
cutters with cartridges. Available in 100 – 200mm, the bodies of the
8010V milling cutters have the same characteristics as the 8000V body
but the distribution of the teeth is regular. The number of teeth is equal
to that of the 8000V series.
The 8010V is best used for rough milling, semi-finishing and finishing of
Titanium and High Temperature Alloys.
Precautions
At speeds above 80 m/min., the differential pitch of the 8000V becomes
essential to reduce the possibility of vibration.
The capability of the 8000V-8010V series is dependent on the different
assembly options.
A108 www.kennametal.su
для заказа - kennametal@kennametal.su
