Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

KMT STELLRAM - полный каталог инструмента - 2014 год EN

                               для размещения заказа - kennametal@kennametal.su                                                                          7700VR
                                                                                                                                             Technical Information

7700VR Technical Information

                                                          Working Diameter:

                                                          D =	 D + 2 x                                       r2 - (r -ap)2                                                 Contour Mills
                                                               w2

r                                  ap                     	 					
                                                          where:	Dw	 =	 Working Diameter
               D2
              Dw                                          				                         D 		 =	 Diameter of cutter insert centre to centre
                                                                                            2

                                                          				                         r		 =	 Insert radius

                                                          				                         a	     	  = 	Axial Depth of Cut
                                                                                           p

7710VR Technical Information

                                                                                       Formula to find programmed feed rate based on radial engagement and

                                                                                       axial depth of cut.	              hm 	
                                                                                                               							
                                                                                                                   fz =

 where:                                                                                                                              2                            2

	fz	 =	 Feed per tooth                                                                                       r2 -(r - ae)                r2 - (r - ap)
	hm	=	 Average chip thickness                                                                                	x                          	
	r =	 Insert radius
                                                                                                                  r                           r
       	
                               	ae	= Radial Depth of Cut
                               	ap	 = Axial Depth of Cut

                                                                                       Formula to calculate the average chip thickness hm in relation with radial
                                                                                       engagement and depth of cut.	

                                                                                                 hm = fz x                            2                           2

                                                                                                             r2 - (r - ae)               r2 - (r - ap)
                                                                                                             	x                          	

                                                                                                                  r                           r

Simplified formulas to evaluate hm and fz based on radial engagement or depth of cut.

Calculation of the average chip thickness in relation with the D.O.C. (Axial)

Formula: Programme Feed Rate (fz)  hm	 =	Average chip thickness                                  Formula: Average Chip Thickness (hm)
                                   ap	 =	Depth of cut
fz = hm x          d               fz	 =	Feed per tooth                                                      hm = fz x                   ap
                   ap              d	 = 	Insert diameter                                                                                 d

Calculation of the average chip thickness in relation with the ae (Radial Engagement) if ae is less than 50% of Dia.

Formula: Programme Feed Rate (fz)  hm	 =	Average chip thickness                                  Formula: Average Chip Thickness (hm)
                                   ae	 =	Radial engagement
fz = hm x          d               fz	 =	Feed per tooth                                                      hm = fz x                   ae
                   ae              d	 = 	Cutter diameter                                                                                 d

www.kennametal.su                                                                                                                                                    A215

                                   для заказа - kennametal@kennametal.su
Заявка