KMT STELLRAM - полный каталог инструмента - 2014 год EN

                   для размещения заказа - kennametal@kennametal.su             Cutting Geometries

-421                                                                      -421                      Milling Inserts

This high positive geometry with high accuracy periphery grinding.
For use in semi-finishing and finishing applications. Due to the precise
control of the cutting edge, this geometry provides excellent results
when machining High Temperature Alloys.

-422                                                                      -422

This positive geometry with a 11 chip angle and an “E” edge
preparation for roughing and semi finishing applications. Primarily for
machining of Stainless Steels and High Temperature Alloys. Also can
be used in Steel, Steel Alloys and Cast Irons with very good results.

-423                                                                      -423

A strong positive geometry first with a smaller primary angle and a
small controlled hone to reduce cutting pressures, followed by a higher
secondary angle to allow free cutting of the chip without rubbing on the
insert rake face. Chip flow compresses the chip for easy evacuation.
For roughing and semi-finishing of Nickel Based Alloys, Cobalt Alloys,
Stainless Steels, Titanium Alloys and High Temperature Alloys.

-441                                                                      -441

This geometry is a peripheral ground insert with a sharp cutting edge
for use on Aluminium Alloys, Copper and Brass. The –441 geometry
provides freer cutting operations and reduces the “suction effect”
associated with higher helical geometries.

www.kennametal.su                                                               A21

                   для заказа - kennametal@kennametal.su