KMT STELLRAM - полный каталог инструмента - 2014 год EN

                                  для размещения заказа - kennametal@kennametal.su                                                                  Negative/Positive
                                                                                                                                          First Choice — Hard Materials

                Negative Inserts – Hard Materials                                                                                                       Metric           Introduction

                                                                                                                                                 ap (mm)
                                                                                                                                                 0,5 - 2,0

                                                                          ap (mm)
                                                                          0,5 - 1,0

                                  ap (mm)                                                                             fn (mm/rev)
                                  0,5 - 1,0                                                                            0,1 - 0,25

D.O.C. ap (mm)                                              fn (mm/rev)
                                                             0,1 - 0,25

                fn (mm/rev)
                 0,1 - 0,25

                                                                                                                                   NL200         NL200

                                                                                                                                   4UVc (m/min)  Vc (m/min)
                                                                                                                                     20 -50        30 -70

                                                   SP0819                                                    SP0819                         NL200
                                                                                                                                          Vc (m/min)
                                   1B Vc (m/min)                                       1B Vc (m/min)
                                                   40 - 85                                                    40 -85                       50 -120
                                                                                                     SP0819
                                          SP0819                                                   Vc (m/min)                      ROUGHING
                                         Vc (m/min)
                                          65 - 140                                                   65 -140

                             FINISHING                                           MEDIUM

0,0                                                                       Feed fn (mm/rev)

                Positive Inserts – Hard Materials                                                                                                       Metric

                                                                          ap (mm)
                                                                          0,25 - 1,0

D.O.C. ap (mm)                                              fn (mm/rev)
                                                            0,025 - 0,15

                                                                                                                            SP4019

                                                              62 Vc (m/min)
                                                                                                                             40 - 80
                                                                                                                    SP4019
                                                                                                                   Vc (m/min)

                                                                                                                    60 - 130

                                                  FINISHING

0,0 Feed fn (mm/rev)

            Please note the above recommended cutting speeds, geometries and grades are for guidance only.
  For more detailed information, see pages C12 - C23 (geometry technical information & grade technical information).

                             Key                            Interrupted   Varying depth                                 Good
                                                                 cut           of cut                                 condition

www.kennametal.su                                                                                                                                               C11

                                                            для заказа - kennametal@kennametal.su