KMT STELLRAM - полный каталог инструмента - 2014 год EN

                        7745VS                     для размещения заказа - kennametal@kennametal.su
                        Technical Information

End Mills & Face Mills  7745VS Technical Information

                        Feed rate compensation: For 45° cutting, divide the hm value by the
                        sine of the approach angle (the sine of 45° = 0,707)

                        i.e.: hm 	 or 	            0,08
                                  0,707 		         0,707	 = 0,11mm programmed feed rate

                        Calculation of the average chip thickness in relation with the ae (Radial Engagement) if ae is less than 50% of Dia.

                        Formula: Programme Feed Rate (fz)  hm	 =	Average chip thickness      Formula: Average Chip Thickness (hm)
                                                           ae	 =	Radial engagement
                        fz = hm x              d           fz	 =	Feed per tooth                      hm = fz x  ae
                                               ae          d	 = 	Cutter diameter                                d

                        A94 www.kennametal.su

                                                                                        для заказа - kennametal@kennametal.su