для размещения заказа - kennametal@kennametal.su 5720VZ16
Profiling / Pocketing Milling Cutters
5720VZ Technical Information (mm)
Product Dimensions
EDP Item Description Facing Ramping Helical Hole ap max Max
Pitch Angle ° min. - max. Helical / RPM
Linear
034614 5720VZ16CA025Z2R75 25 14.5* 29,5 48,0 50000 Ramping Helical
034617 5720VZ16CA032Z2R75 32 11.4* 43,5 62,0 4,00 41500 Interpolation
034640 5720VZ16CA032Z3R75 32 11.4* 43,5 62,0 4,00 41500
4,00 Flat
59,5 78,0 36500
034619 5720VZ16-A040Z3R 40 7.6* 79,5 98,0 4,00 30000 Facing Pitch
031325 5720VZ16-A050Z03R 50 7.9* 79,5 98,0 4,00 30000
031326 5720VZ16-A050Z4R 50 7.9* 105,5 124,0 4,00 26000
031328 5720VZ16-A063Z05R 63 5.9* 105,5 124,0 4,00 26000
031327 5720VZ16-A063Z4R 63 5.9* 139,5 158,0 4,00 23000
031329 5720VZ16-A080Z04R 80 4.4* 139,5 158,0 4,00 23000
031330 5720VZ16-A080Z05R 80 4.4* 4,00
29,5 48,0 50000
034616 5720VZ16SA025Z2R50 25 14.5* 43,5 62,0 4,00 41500
034618 5720VZ16SA032Z2R50 32 11.4* 43,5 62,0 4,00 41500
031639 5720VZ16SA032Z3R50 32 11.4* 4,00
* Max. ramping angle for insert is calculated with facet
Find the different ramping angles for all available insert radii on technical information page 81.
Radial depth of cut 0,20mm up to full cutter diameter.
These tools have been designed, manufactured and tested in accordance with
EN ISO standard 15641:2001.
These tools are stocked without an electronic chip.
Note: If using a insert with radius, then the facing pitch for the 5702VZ cutter is equal to the
cutting diameter (D) minus 2 x chosen radius.
Cylindrical Shanks or Special HSK Integral Shanks are designed and balanced to G6.3 at
30,000 RPM for diameters 50mm and below. Diameters larger then 50mm are balanced to
G6.3 at 24,000 rpm.
Cylindrical Shank tools mounted in a shrink fit holder or any other mill chuck holder + inserts +
screws must be re-inspected for balance as an assembly by the end user when at or
exceeding 8,000 rpm. End user must balance the assembly to a G6.3 value minimum.
Shell Mills and Modular Heads are not balanced. These tools must be re-inspected for
balance as an assembly, cutter + adapter + inserts + screws by the end user when at or
exceeding 8,000 rpm. End user must balance the assembly to a G6.3 value minimum.
Additional Balancing and Torque values can be found in the technical section pages 82.
www.kennametal.su 79
для заказа - kennametal@kennametal.su
