KMT STELLRAM - полный каталог инструмента

                   для размещения заказа - kennametal@kennametal.su                              80.0VSE45-_R-12 Series
                                                                                                 Cartridge Face Milling Cutter

45° CARTRIDGE FACE MILLING ASSEMBLIES                                                                                                              Facing Spiral / Circular
The 80.0VSE45 cutter series is primarily designed to machine Stainless Steel and High
Temperature Alloys. Also Steel, Steel Alloys, Cast Iron and Aluminium can be machined.           80_0VSE-45-_R-12
Especially, if thin wall components need to be machined. Due to its very positive design
requires this cutter series lower power.                                                         8000VSE45-_R-12:
                                                                                                 Maximum ap = 7,00mm
The square inserts design with 15° degrees clearance and very positive chip geometry is          Effective Cutting Diameter
ideal for reducing build-up edge on tough materials.                                             Range = 100mm to 400mm
                                                                                                 ** Denotes non stock items diameter
Applications:                                                                                    315mm - 400mm
The 80.0VSE45 cutters are assembled with cartridges for SD..1204.. milling inserts. These
cutters are ideal for face milling applications. Available with medium pitch.                    8010VSE45-_R-12:
                                                                                                 Maximum ap = 7,00mm
The 8000VSE45 cutter series has an unequal medium pitch for reducing vibration and are           Effective Cutting Diameter
mainly for roughing, semi-finishing and finishing of Steel, Steel Alloys, Stainless Steel, Cast  Range = = 100mm to 200mm
Iron and Aluminium.                                                                              ** Denotes non stock items diameter
                                                                                                 100mm - 200mm
The 8010VSE45 cutters series has an equal medium pitch and is especially recommended
for roughing, semi-finishing and finishing of High Temperature Alloys such as Iron Based
Alloys, Cobalt Based Alloys, Nickel Based Alloys and Titanium.

Also, the 8000VSE45 cutter series can be mounted with a particular wiper cartridge for
finishing when a fine finished surface is required. The corresponding pocket on the body for
the finishing cartridge is marked with a “F”.

Note: The 8010 series are not possible to assemble with a wiper cartridge.

www.kennametal.su                                                                                A141

                   для заказа - kennametal@kennametal.su
KMT STELLRAM - полный каталог инструмента - 2014 год EN
