Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

KMT STELLRAM - полный каталог инструмента - 2014 год EN

                               для размещения заказа - kennametal@kennametal.su                                       80.0VR00-_R-20 Series
                                                                                                                            Technical Information

80.0VR00-_R-20 Technical Information                                    Working Diameter:                                                              Cartridge Face Mills

                                                                    ap  Formula to evaluate the correct working diameter
                              D2
                               Dw                                       based  on  axial  depth  of  cut  (ap).
                                                                        	

                                                                        Dw =	 D2 + 2 x                           r2 - (r -ap)2

                                                                        	 					

                                                                        where:	Dw	 =	 Working Diameter

                                                                        				              D2		 =	 Diameter of cutter insert centre to centre

                                                                        				              r		 =	 Insert radius

                                                                        				              ap		 = 	Axial Depth of Cut

80.0VR00-_R-20 Technical Information

                                                                        Formula to find programmed feed rate based on radial engagement and
                                                                        axial depth of cut.	

                                                                                          							 hm 	
                                                                                                fz =

where:                                                                                                           r2 -(r - )ae 2  r2 -(r - )ap 2

	fz	 =	 Feed per tooth         	ae	= Radial Depth of Cut                                                         	x              	
                               	ap	 = Axial Depth of Cut                                                              r               r

	hm	=	 Average chip thickness

	r        =	 Insert radius                                              Formula to calculate the average chip thickness hm in relation with radial
       	                                                                engagement and depth of cut.	

                                                                                                 hm = fz x       r2 -(r - )ae 2  r2 -(r - )ap 2

                                                                                                                 	x              	
                                                                                                                      r               r

www.kennametal.su                                                                                                                                A159

                               для заказа - kennametal@kennametal.su
Заявка