Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

KMT STELLRAM - полный каталог инструмента - 2014 год EN

                5210VS                     для размещения заказа - kennametal@kennametal.su
                Technical Information

                Calculation of the average chip thickness in relation with the ae (Radial Engagement) if ae is less than 50% of dia.

Shoulder Mills  Formula: Programme Feed Rate (fz)       hm	 =	Average chip thickness           Formula: Average Chip Thickness (hm)
                                                        ae	 =	Radial engagement
                      fz = hm x        d                fz	 =	Feed per tooth                   hm = fz x  ae
                                       ae               d	 = 	Cutter diameter                             d

                Multiplication factor for the feed rate based on the percentage of radial engagement of the cutter diameter

                ae %      Cutter  32mm    Coefficient  ae %      Cutter  80mm   Coefficient  ae %      Cutter  100mm   Coefficient
                                             Factor                                 Factor                                  Factor
                   5          ae mm                        5          ae mm                       5          ae mm
                   10                          2,30        10                         2,30        10                          2,30
                   15           1,60           1,66        15           4,00          1,66        15            5,00          1,66
                   20           3,20           1,40        20           8,00          1,40        20           10,00          1,40
                   25           4,80           1,25        25          12,00          1,25        25           15,00          1,25
                   35           6,40           1,16        35          16,00          1,16        35           20,00          1,16
                50 - 100        8,00           1,05     50 - 100       20,00          1,05     50 - 100        25,00          1,05
                               11,20           1,00                    28,00          1,00                     35,00          1,00
                           16,00 - 32,00                           40,00 - 80,00                          50,00 - 100,00

                Example: 80mm diameter cutter using a 8,0mm radial engagement (ae) = 10% of the cutter diameter. 				
                At 10%, your coefficient is 1,66 (see chart); therefore you must multiply your feed rate by 1,66 for correcting the feed for profiling.

                A170                                                                                      www.kennametal.su

                                                        для заказа - kennametal@kennametal.su
Заявка