для размещения заказа - kennametal@kennametal.su 7702VRD & 7712VRD Series
Technical Information
7702VRD & 7712VRD Technical Information
Working Diameter:
Formula to evaluate the correct working diameter
based on axial depth of cut (ap).
Contour Mills
r ap Dw = D2 + 2 x r2 - (r -ap)2
D2
Dw where: D = Working Diameter
w
D2 = Diameter of cutter insert centre to centre
r = Insert radius
a = Axial Depth of Cut
p
7702VRD & 7712VRD Technical Information
Formula to find programmed feed rate based on radial engagement and
axial depth of cut. hm
fz =
( )r2 - r - ae 2 ( )r2 - r - ap 2
x
where: r
r
fz = Feed per tooth ae = Radial Depth of Cut
ap = Axial Depth of Cut
hm = Average chip thickness
r = Insert radius Formula to calculate the average chip thickness hm in relation with radial
engagement and depth of cut.
hm = fz x ( )r2 - r - ae 2 ( )r2 - r - ap 2
x
r r
Simplified formulas to evaluate hm and fz based on radial engagement or depth of cut.
Calculation of the average chip thickness in relation with the D.O.C. (Axial)
Formula: Programme Feed Rate (fz) hm = Average chip thickness Formula: Average Chip Thickness (hm)
ap = Depth of cut
fz = hm x d fz = Feed per tooth hm = fz x ap
ap d = Insert diameter d
Calculation of the average chip thickness in relation with the ae (Radial Engagement) if ae is less than 50% of Dia.
Formula: Programme Feed Rate (fz) hm = Average chip thickness Formula: Average Chip Thickness (hm)
ae = Radial engagement
fz = hm x d fz = Feed per tooth hm = fz x ae
ae d = Cutter diameter d
www.kennametal.su A227
для заказа - kennametal@kennametal.su