KMT STELLRAM - полный каталог инструмента - 2014 год EN
Negative/Positive для размещения заказа - kennametal@kennametal.su
First Choice — Cast Iron
Introduction Negative Inserts – Cast Iron Metric
D.O.C. ap (mm)
ap (mm)
0,5 - 9,0
ap (mm)
0,5 - 4,0
ap (mm) fn (mm/rev)
0,5 - 4,0 0,2 - 0,6
fn (mm/rev)
0,1 - 0,55
fn (mm/rev)
0,1 - 0,55
NL250 NL250
Vc (m/min) PLATE Vc (m/min)
40 - 150 4U 60 - 225
NL200 NL200
Flat NL200 Flat
4UVc (m/min) Vc (m/min)
NL200 NL200 60 - 245 Vc (m/min)
40 - 165
4UVc (m/min) Vc (m/min) 95 - 410
60 - 245 NL200 4U
40 - 165 Vc (m/min)
95 - 410
NL200 ROUGHING
Vc (m/min)
95 - 410 MEDIUM
FINISHING
0,0 Feed fn (mm/rev)
Positive Inserts – Cast Iron Metric
ap (mm)
0,4 - 5,0
ap (mm)
0,25 - 3,0
D.O.C. ap (mm) fn (mm/rev)
0,07 - 0,5
fn (mm/rev)
0,025 - 0,25
NL920 NL300
73Vc (m/min) Vc (m/min)
25 - 80 55 - 200
SP4019 NL300
Vc (m/min)
62 Vc (m/min) 90 - 335
70 - 265
MEDIUM-
SP4019 ROUGHING
Vc (m/min)
120 - 440
FINISHING
0,0 Feed fn (mm/rev)
Please note the above recommended cutting speeds, geometries and grades are for guidance only.
For more detailed information, see pages C12 - C23 (geometry technical information & grade technical information).
Key Interrupted Varying depth Good
cut of cut condition
C8 www.kennametal.su
для заказа - kennametal@kennametal.su