KMT STELLRAM - полный каталог инструмента

                        для размещения заказа - kennametal@kennametal.su                                                  Negative/Positive
                                                                                                            First Choice — Aluminum & Alloys

Negative Inserts – Aluminum & Alloys                                                                        Metric                            Introduction

                                                                     ap (mm)
                                                                     1,0 - 3,0

D.O.C. ap (mm)                       fn (mm/rev)
                                      0,2 - 0,35

0,0                                                                     SP0819

                                                  3F Vc (m/min)
                                                                       165 - 585
                                                                SP0819
                                                              Vc (m/min)

                                                               275 - 975

                                            MEDIUM

                                     Feed fn (mm/rev)

                Positive Inserts – Aluminum & Alloys                                                        Metric

                                                                                                ap (mm)
                                                                                                2,0 - 6,0

                                     ap (mm)
                                     0,8 - 2,0

D.O.C. ap (mm)                                                       fn (mm/rev)
                                                                      0,35 - 0,6

                        fn (mm/rev)
                         0,05 - 0,2

                                                                                  GH1 GH1

                                                                                  64Vc (m/min)  Vc (m/min)
                                                                                                110 - 495
                                                                                   70 - 330

                                                             GH1                       GH1
                                                                                    Vc (m/min)
                                           -X Vc (m/min)                             180 -825
                                                          110 - 495
                                                                                   MEDIUM-
                                                    GH1                           ROUGHING
                                                 Vc (m/min)
                                                 180 - 825

                                     FINISHING

0.0                                  Feed fn (mm/rev)

          Please note the above recommended cutting speeds, geometries and grades are for guidance only.
For more detailed information, see pages C12 - C23 (geometry technical information & grade technical information).

                   Key               Interrupted                     Varying depth                Good
                                          cut                             of cut                condition

www.kennametal.su                                                                                                   C9

                                     для заказа - kennametal@kennametal.su
KMT STELLRAM - полный каталог инструмента - 2014 год EN
