KMT STELLRAM - полный каталог инструмента - 2014 год EN

                         для размещения заказа - kennametal@kennametal.su                            Positive Insert Geometries
                                                                                                                           -M Inserts

-M Geometry Technical Information                                          VCMT160408E-M         SteUenal:llo7y5ed0 S-te9e5l:0      750 - 950 N/mm2    HBN  -  270

Medium to Finishing:                                                        UVCnMaT3l3l2oAy-Med                                 N/mm222H0 -B27N0     220
                                                                           ap (depth of cut)
The -M Geometry has a small, well defined chip-breaker for a soft cutting         ap (depth of cut)inch mmVCMT160408E-M
action, resulting in very little stress being produced, when machining     0.138 3,50
small diameter components.                                                                                                                                   Introduction
Available in Grades: SP4019 & GH1

                                                                           0.118 3,00

  Materials Application  Cutting Condition                                 0.100 2,50
         SP4019
                                                                           0.080 2,00
P M KNSH
                            4     4         8                              0.060 1,50
           GH1                                                             0.040 1,00
                         Profile                                                                 -M
P M KNSH

                                                                           0.020 0,50

                                                                           mm 0,10               0,20 0,30 0,40                 0,50                 0,60
                                                                           inch 0.004                                           0.020                0.023
                                                                                                 0.008 fn 0(f.e01e2d/rev0).016
                                                                                                       fn (feed/rev)

                        Material Guide – Key to Recommended Inserts

                                                           Material Designation

PP Unalloyed Steels PP Alloyed Steels MM Stainless Steels MM PHStainless KK Cast Irons NN Aluminum & Alloys SS High Temp. Alloys HH Hard Materials

www.kennametal.su                                                                                                                                              C21

                                  для заказа - kennametal@kennametal.su