Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

KMT STELLRAM - полный каталог инструмента - 2014 год EN

                   для размещения заказа - kennametal@kennametal.su                                            8000V-8010V
                                                                                                              Surface Finishing

                   Surface Finishing with 81FS00 Cartridges                                                                      Cartridge Face Mills

                   The cartridge 81 FS 00 R-12 is intended to perform finishing operations when used in
                   conjunction with other cartridges as shown in the diagram opposite. They have a fine
                   adjusting set screw to enable the cartridge to be pulled back and pushed forward again
                   to the initial preset position.

                   Stock removal for finishing should be no more than 1 mm and preferably 0,5 mm. The
                   finishing insert actually removing a maximum 0,03 mm due to it trailing the main cutting
                   inserts.

                   On the cutter series 8000V one, two or even three (according to diameter) of the roughing
                   cartridges may be replaced by an 81 FS 00 R-12 finishing cartridge. One corresponding
                   pocket for a wiper cartridge is marked with an “F”.

                   These cartridges, having a fine adjusting set screw, are set according to the dimension
                   (axial shift) “X”.

                   X	 =	0,03 - 0,05 mm

                   (X	 =	0,02 mm with a pressed insert with a nose radius)

                   Maximum feed up to 3 mm/rev.

                                                 X                                          X                       X

                   8000VR00 (R-16 only)                            8000VS / VSE45              8000VOD45

                   Note: 8000V Series assemblies that cannot use wiper cartridges are 90 degree A-Style, 20mm
                   Round Button and 12mm and 16mm High Feed Mills.

                   Also, all 8010V cutter series are not possible to assemble with a wiper insert cartridge.

                             Product                                      Spares

                            Finishing Insert           Finishing   Cartridge Fixing Adjusting  Fixing Insert  Screwdriver
                             Part Number              Cartridge    Screw  Cartridge Screw         Screw           T20
                                                    81 FS 00 R-12                                D5013T
                   SPHX 12 M5 12-EN                                7065 72.602

www.kennametal.su                                                                                              A161

                   для заказа - kennametal@kennametal.su
Заявка