Ниже представлена эта же страница в формате, позволяющем производить копирование текста.

KMT STELLRAM - полный каталог инструмента - 2014 год EN

                      8000V-8010V                      для размещения заказа - kennametal@kennametal.su
                      Mounting / Adjusting Cartridges

Cartridge Face Mills                                    General Cartridge Mounting Instructions

                                                                For the majority of current applications, 8000V and 8010V cutters with interchangeable
                                                                cartridges do not have to be adjusted. The cartridges therefore are mounted by pressing
                      1 the calibrated heel up against the setting track on the tool body (runout 0,05 mm max.,
                                                                with inserts with ground wiper edges). However, if greater accuracy is required, they may
                                                                be adjusted individually with a runout of 2-µm.
                        2

                                                            A Mounting of Cartridges without Adjustment
                                                                    1. Lubricate the screw under the head and on the thread (preferably
                                                                       with copper paste).
                                                                    2. Clean cartridges and their pockets located in the milling cutter.
                                                                    3. Introduce the first cartridge into its pocket and check if it moves freely.
                                                                    4. Introduce screw No. 1 and tighten it moderately whilst pushing the cartridge
                                                                       against its axial setting track; mount all the cartridges in the same way.
                                                                    5. Introduce screw No. 2 and lock it (tightening torque 10 Nm).
                                                                    6. Lock screw No. 1 well with an extended allen key (tightening torque 18 Nm).
                                                                    7. Mount the indexable inserts.

                      A162                                                                               www.kennametal.su

                                                       для заказа - kennametal@kennametal.su
Заявка